Marmitek IR Control8 User Manual download pdf (Page 5)

To check the proper working of the system it is advisable first to test the formation as

planned. For this reason connect everything as described as follows but don’t fix or screw the

components yet.

1. Install the IR Module at a place within reach behind or next to your A/V equipment and

near a 230V plug (100-240Volt 50/60Hz). Take into account the length of the cable of

the IR LEDs and make sure that the connections are kept accessible if possible.

Plug the required IR Extension cables (with the 2 IR LEDs) into the IR Module (Picture 1 nr. 4).

A self-adhesive foil is supplied with the IR LEDs. With that you can fasten the IR LEDs to

the IR window of your A/V equipment. Note: it’s tricky work. First test the position and

working of the IR LEDs before fixing them permanently to the IR window of your A/V

equipment. Note: If you use only one of the 2 LEDs, then leave the second IR LED

unused. Never remove it from the IR extension cable!

3. Now connect the IR Receiver to the IR Module, for your convenience the connection clip

has been connected to the wiring of the IR Receiver, take care when plugging in of the

correct position (nuts up) and colours of the wiring. When you have to disconnect the

wiring for instance because a connecting clip won’t go through a hole in the furniture,

connect afterwards the wiring to the clip according to the connection scheme in Picture 2.

4. Place the supplied IR receiver in such a way that it is visible for your infrared remote

control. The infrared LED indicator on the IR receiver lights up or flashes when it receives

an infrared signal. Use the LED indicator to place the IR receiver in the place with the

least interference (LED indicator is not activated or only faintly lights up). Because of the

supplied self-adhesive strip installation is possible almost everywhere. Experiment for the

correct place before you fix the IR receiver definitively. Note: The adhesive strip can cause

discoloration on certain surfaces or leave glue remnants by removal.

5. Connect the power adapter to the ‘POWER’ connection of the IR module and plug the

adapter to a wall plug. Check if the ‘POWER’ LED is on.

5IR CONTROL 8

ENGLISH

V+

Picture 2

IR Module

IR LEDs

(Max. 4 IR extender cables)

IR Receiver

(Max. 3)

V+ = Orange

G = Blue

ST = Purple

IR = Yellow

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Marmitek IR Control8 User Manual Page 5