Marmitek X-10 Micromodule User Manual

TWM4™MICRO MODULE TRANSMITTER20246/20080220 • TWM4™ Micro module transmitterALL RIGHTS RESERVED MARMITEK © LAUNAM RESU 3

© MARMITEK10PROGRAMMINGIntroductionSwitch on the power supply before you start programming. Avoid touching live parts!The introduction to this chapter

TWM4™111. Switch the module to Programming modeIn order to program the interface module, it must be set in to the Programming mode as follows:• Pres

© MARMITEK123. Programming a function codeDetermine the function of the module by sending the set-up command belonging to the function twice via the

TWM4™13ExampleA switch actuator is controlled using a TWM4, operated with a (rocker) switch. The switch actuator responds to the group commands All Li

© MARMITEK146. Test the operation of all the inputsProgramming per function This chapter explains the actions that need to be performed to program the

TWM4™15Input Address Sending* OperationBrown B03 ON/OFF Send ON or OFF commands*Red B04 ON/OFF Send ON or OFF commands*Orange B05 ON/OFF Send ON or OF

© MARMITEK16Optional:If the status of the module has to change with group commands All Lights On and All Units Off.Action No. of LED flashesSend All L

TWM4™17Action SendingSend address (2 x) A1...P16Send set-up command (2 x) DIMOptions NoneExample of programming with address B03Action No. of LED flas

© MARMITEK183.4 Sending group commands with (rocker) switches or Momentary switchesAction SendingSend address (2 x) A1...P16Send set-up command (2 x)

TWM4™19FREQUENTLY ASKED QUESTIONSWhat is the reason for modules to switch on/off spontaneously?It is possible that a Marmitek X-10 System is installed

© MARMITEK2

© MARMITEK20• Press the “brt” button 2x (=VOL+).• The MicroModule responds by blinking the LED 5x.• Cancel the MicroModule programming mode.Address B3

TWM4™39DECLARATION OF CONFORMITYHereby, Marmitek BV, declares that this TWM4 is in compliance with the essential requirements and other relevant prov

TWM4™3SAFETY WARNINGS• The wiring of your electrical installation is live (230 V) and extremely dangerous. Never connect the module when plugged into

© MARMITEK4HOW DOES MARMITEK X-10 WORK?Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek X-10 signals). You can bu

TWM4™5if wall outlets and lighting points are actually divided into several phases (several groups is no problem for the Marmitek X-10 signal). 2. It

© MARMITEK6on each phase entering the house. These filters will block signals coming into or going out of your house, but will also match the impedanc

TWM4™7CONNECTION APPLICATIONSSuitable for the connection of:• Four 1-pole (rocker) switches.• Four 1-pole, normally open contact, Momentary switches

© MARMITEK8Installation/assembly behind switches & Momentary switchesAlways switch off the power before commencing installation!• When present ta

TWM4™9• Position the module with the back against the rear of the back box, behind the wiring.• If the module has not yet been programmed or has bee