Marmitek X-10 User Manual download pdf (Page 10)

FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off

spontaneously?

It is possible that a Marmitek X-10 System is installed at one

of your neighbours using the same House Code. To solve this

problem try to change the House Code of your system, or

have FD10 Phase Coupler/Filter installed at your incoming

mains.

My modules will not respond to my controller.

Make sure that the House Code on all Modules and

Controllers are set to the same House Code (A .. P).

Am I able to increase the range of my remotes by using

more Transceivers?

Yes, you can use more than one TM13 Transceiver in your

home when the range of your remotes is not sufficient. The

TM13 is using so called collision detection to prevent signals

to be disturbed when more than one TM13 is transmitting.

TM13’s will wait for a quite power line before transmitting their

data. To prevent your Marmitek X-10 System to become slow

or to prevent dimming from becoming less smooth, make sure

that the TM13 units are placed as far away from each other as

possible.

Do you have other questions that have not been resolved by

the above information? Please go to www.marmitek.com

1 2 ... 5 6 7 8 9 10 11 12 13

No comments

Marmitek X-10 User Manual Page 10