Marmitek SWM1P User Manual download pdf (Page 4)

HOW DOES MARMITEK X-10 WORK?

Marmitek X-10 components use the existing mains wiring to communicate

(using Marmitek X-10 signals). You can build a complete system using the

three different kinds of components of the Marmitek X-10 System:

1. Modules: These components will receive Marmitek X-10 signals and

will switch or dim the attached lamp or appliance. Examples

of these modules are lamp modules and appliance modules.

These are available as build-in, micro, DIN rail and plug-in

modules.

2. Controllers: These components will transmit Marmitek X-10 signals and

thus will control the Modules.

3. Transmitters: Wireless components like remotes. The signals of these

components will be received by a controller with transceiver

functionality (IRRF7243, TM13 or CM15Pro). The Transceiver

will translate the signals into Marmitek X-10 signals on the

power line.

ADDRESSES

Up to a maximum of 256 different addresses can be preset. These are subdi-

vided into a so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.).

The HouseCode can also be set on the controllers, so that the controllers and

modules become part of the same system. The address can be set either using

code dials or by pressing buttons, depending on the type of module.

The Marmitek X-10 System uses standard commands, which control all units

with the same HouseCode at the same time (e.g. all lights on, all off, etc.).

SIGNAL RANGE

Range of Marmitek X-10 signals over the Power Line and how to

increase the range.

The Marmitek X-10 System is based on power line communication. The range

of the Marmitek X-10 signals very much depends on the local circumstances.

On average the range is a cable length of 80 meters.

If you have difficulties with the range of your Marmitek X-10 signals,

please pay attention to the following facts:

1. When more than one phase is used for your electrical system, it is necessary

to couple these phases for the Marmitek X-10 signals. For coupling you can

use FD10 Phase Couplers/Filters. You only need to install a Phase Coupler/Filter

when your wall outlets and light switches are divided over more than one

phase (more than one group is no problem). For bigger buildings or longer

1 2 3 4 5 6 7 8 9 ... 47 48

No comments

Marmitek SWM1P User Manual Page 4