Marmitek GSM800 User Manual download pdf (Page 4)

3 © MARMITEK

Figure 2.4: Opening the Housing

Housing

Screw

Switching off the siren

1. Press 9 followed by 1111.

2. Now enter 9155 (the display shows: 5.WIRED SIREN ENABLED).

3. Now press  (the display shows: 5.WIRED SIREN DISABLED).

4. Press 9 for confirmation.

5. Press 8 4 times to leave the installation menu.

INSTALLATION

1. Disconnect the AC power from the ProGuard800 control panel.

2. Remove the housing screw located at the bottom of the front cover.

3. Using a screwdriver carefully press the release tabs as shown in Figure 2.4.

4. Lift the front cover away from the back of the housing. You will notice that the

front cover is attached to the back with two fastening bands and the keypad’s

flat cable.

5. Disconnect the backup battery pack connector to the Control Panel.

6. Slide the GSM800 PCB at it’s place by first putting the right side of the pcb in

place and then clicking the left side in it’s holder. Make sure connectors are at

the bottom of the PCB.

7. Connect the small flat cable between the GSM800 PCB (5) and the Control

Panel (Main Board) PCB.

8. Put the plug in the socket.

9. Follow these steps in the ProGuard800 Installation manual:

12.5: Find Modules

10.7.2: PIN Code

10.7.3: SMS Center

10. Place the SIM card in the SIM card holder.

1 2 3 4 5 6 7 8 9 ... 27 28

No comments

Marmitek GSM800 User Manual Page 4