Marmitek EASY ICON 10 RF User Manual download pdf (Page 3)

HOW DOES MARMITEK X-10 WORK?

Marmitek X-10 components use the existing mains wiring to communicate (using

Marmitek X-10 signals). You can build a complete system using the three different kind

of components of the Marmitek X-10 System:

1. Modules: These components will receive Marmitek X-10 signals and will switch

or dim the attached lamp or appliance. Examples of these modules

are lamp modules and appliance modules. These are available as

build-in, micro, DIN rail and plug-in modules.

2. Controllers: These components will transmit Marmitek X-10 signals and thus will

control the Modules.

3. Transmitters: Wireless components like remotes. The signals of these components

will be received by a controller with transceiver functionality (IRRF

7243, TM13 or CM15Pro). The Transceiver will translate the signals

into Marmitek X-10 signals on the power line.

ADRESSES

Up to a maximum of 256 different addresses can be preset. These are subdivided into a

so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can

also be set on the controllers, so that the controllers and modules become part of the

same system. The address can be set either using code dials or by pressing buttons,

depending on the type of module.

The Marmitek X-10 System uses standard commands, which control all units with the

same HouseCode at the same time (e.g. all lights on, all off, etc.).

SIGNAL RANGE

Range of Marmitek X-10 signals over the Power Line and how to increase the

range.

The Marmitek X-10 System is based on power line communication. The range of the

Marmitek X-10 signals very much depends on the local circumstances. On average the

range is a cable length of 80 meters.

If you have difficulties with the range of your Marmitek X-10 signals, please

pay attention to the following facts:

1. When more than one phase is used for your electrical system, it is necessary to cou-

ple these phases for the Marmitek X-10 signals. For coupling you can use FD10 Phase

Couplers/Filters. You only need to install a Phase Coupler/Filter when your wall outlets

and light switches are divided over more than one phase (more than one group is no

problem). For bigger buildings or longer distances we advice you to use an active

repeater instead of passive FD10’s.

2. It is possible that Marmitek X-10 signals are attenuated by devices and lights which

4 © MARMITEK

1 2 3 4 5 6 7 8 ... 14 15

No comments

Marmitek EASY ICON 10 RF User Manual Page 3