Marmitek EASY ICON 10 RF User Manual download pdf (Page 5)

INSTRUCTIONS FOR USE

USING THE WIZARD

After you insert the batteries and choose “English,” the Setup Wizard

screen appears. You can exit the Wizard at any time by pressing the

HOME key (located just below the screen). Follow the instructions on

the Wizard screens to familiarize yourself with the OK, Back, and Side

Keys.

You can go back and forth through the Wizard, but once you’ve set up your devices and

quit to save the settings, you won’t see the Wizard again unless you do a Master Reset.

To do a Master Reset: Press the HOME key, Setup, More, Advanced, Clear

Settings, More, and then Master Clear. Note this will erase everything you have set

up in the remote.

SETTING UP YOUR DEVICE

After you’ve been through the Wizard for the first time, the screen shown to the right

appears. This is the start of the Wizard for setting up your devices (TV being the first

one).

If you know your brand of TV, select Yes, which results in a faster

search for your TV’s code. Selecting No searches the complete library

of TV codes, rather than just the codes for your brand of TV.

Pressing the Side Key for Yes takes you to the screen that shows the

most common brands. Use the Side Keys to select your brand of device.

If your brand isn’t shown, you can press the Side Key adjacent to Next

to show more brands, (shown alphabetically); or press the Side Key

adjacent to Back to go back to the previous screen of brands.

After you select your brand, the next screen tells you to point the remote at your TV

and keep pressing Power until it responds.

Pressing Power sends the Power code to your TV, and the screen shows that you’ve sent

code 1 of xx (xx will vary by brand). Keep pressing Power until your TV responds and

then press Save. (You can press the Side Key adjacent to Last Code if you overshoot).

6 © MARMITEK

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Marmitek EASY ICON 10 RF User Manual Page 5