Marmitek EASY ICON 10 RF User Manual download pdf (Page 8)

you can easily change these names by selecting Home/Setup/Favourites/Rename or

Home/Setup/X10/More Rename.

LEARNING

For the EasyIcon10RF to learn from another remote, do the following:

• Place the 2 remotes on a flat surface (table).

• Ensure that the transmitter end from the original remote is 40 mm

or so away from the receiving end (bottom)

of the EasyIcon10RF.

• Press the key/button on the original remote that you want to learn

from for about a second and release it (press and release).

• Do not press and hold it for an extended period of time.

You can learn commands from an existing remote and store them

under the “Main” Keys on the EasyIcon10RF, or learn commands from

an existing remote and store them under any of the 10 Side Keys.

At the HOME screen press the Side Keys next to Setup, More, and Learn.

The next screen asks, “Where do you want to learn?” The question

means, do you want to learn a command and place it on a Side key of

the EasyIcon10RF, or do you want to learn a Main Key command and

place it on a Main Key of the EasyIcon10RF.

If you press a right Side Key (to select Main Keys) you are going to learn,

say, the Chan Up key from an existing remote and store it under the

Chan Up key on the EasyIcon10RF.

Or, learn the Power key from an existing remote and store it under the

Power key on the EasyIcon10RF, etc.

Select the Device you want to learn keys for. In this example we only have

a TV, Cable Box and Satellite Receiver set up, so the rest are grayed out,

but you can still select any of the devices to learn commands for. You are

then instructed to line up the remotes, and press the key on the

EasyIcon10RF remote that you want to learn, e.g., the Power key.

Then, point the remote you want to learn commands from at the bot-

tom of the EasyIcon10RF. Press and hold (in this example) the Power

key on the other remote until the display shows that the command has

been successfully learned. Note for some types of keys you might need

to hold the key pressed, but for other types a quick press is sufficient.

Experiment a bit. If keys you learn are sent multiple times try learning

them with just a quick press.

If the screen says Failure, you can press the key and try again.

9EASY ICON 10 RF™

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Marmitek EASY ICON 10 RF User Manual Page 8