Marmitek AWM2P User Manual download pdf (Page 10)

10 © MARMITEK

Figure 4

• Install the wall switch at its original place after the MicroModule

is programmed.

Please note: due to heat generation, apply no more than one module

per flush socket / central socket!

Programming

RNING: DO NOT FORGET TO TURN ON THE MAIN MASTER

SWITCH PRIOR TO PROGRAMMING.

Activate the setup mode.

e following steps have to be taken to start the setup procedure for

programming the MicroModule:

• Press the setup (prog.) button for at least 3 seconds (see figure

5). The LED should stay on after releasing the setup button.

• Warning! The MicroModule will leave the setup mode if it

doesn’t receive any commands within 60 seconds.

Exit setup mode

• P

ress the setup button once shortly; The red LED will turn off

now. You can also wait for at least 60 seconds so that the

MicroModule will exit the setup mode automatically.

prog.

SAIX

prog.

SAIX

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Marmitek AWM2P User Manual Page 10