Marmitek AWM2P User Manual download pdf (Page 12)

12 © MARMITEK

program the preferred settings (When you use an RF remote control

like the Marmitek 8-in-1, then a TM13 Plug-in Transceiver is required

to convert the RF signals to the X-10 commands on the power line).

Example 1. Program the Marmitek X-10 address E4:

• S

etup your remote control (see manual 8-in-1) and the TM13

transceiver to house code E.

• Start with the MicroModule in setup mode.

• Press the Marmitek X-10 button (marked with the symbol of a

house) of the 8-in-1 remote control and then press button 4.

• Press the “ON” button 2x (= channel+).

• The MicroModule responds by blinking the LED twice.

• The address E4 is programmed.

Example 2. Program the function “All Units Off”

• Make sure you program the required Marmitek X-10 address

first!! (e.g. E4).

• Leave the remote control and the TM13 Transceiver on

HouseCode E or set it to the right HouseCode.

• Start with the MicroModule in setup mode.

• Press button marked with “All Units Off” 2x (= mute).

• The MicroModule responds by blinking the LED 4x.

NOTES:

• W

hen you program the MicroModule, always program the

address first followed by the optional functions.

• If the MicroModule receives a new address during setup mode,

the optional functions will be automatically reset to the factory

defaults.

• I

f you have programmed the address, but you wish to change it

again you need to switch the AWM2P out of the programming

mode and put it in the programming mode again.

• When programming the AWM2P, do not give the commands

with too little time in between, keep 1 second pauses in between

the commands.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Marmitek AWM2P User Manual Page 12