Marmitek AWM2P User Manual download pdf (Page 13)

13AWM2P™

ENGLISH

When you wish to program the module with the help of a remote

control in combination with an IRRF7243, you need to follow a

slightly different procedure (for instance: setting up UnitCode 2 with

an 8in1 Multimedia remote control):

• push the “house” on the remote control

• push button [2]

• give 2 x an [on] command

• close off with button [2]

An AWM2P cannot send ALL LIGHTS ON or ALL UNITS OFF signals

for the second address itself. It can only receive this signal and based

on this signal, adjust its internal status.

FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?

It is possible that a Marmitek X-10 System is installed at one of your

neighbours using the same House Code. To solve this problem try to

change the House Code of your system, or have FD10 Phase Coupler/

Filter installed at your incoming mains.

My modules will not respond to my controller.

ke sure that the House Code on all Modules and Controllers are

set to the same House Code (A .. P).

My modules will not react to my remote / sensor.

en you use a remote or sensor, you should have at least one TM13

Transceiver, CM15Pro or Marmitek X-10 Security Console installed in

your house. These components will translate the radio signals to the

Marmitek X-10 signal on the power line. Using several remotes and

sensors, you only need one central transceiver.

Am I able to increase the range of my remotes by using more

Transceivers?

s, you can use more than one TM13 Transceiver in your home

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

No comments

Marmitek AWM2P User Manual Page 13