Marmitek AWM2P User Manual download pdf (Page 6)

6 © MARMITEK

Marmitek X-10 signals are disturbed by e.g. baby phones which

are in TALK mode (continuous transmission). When these kind

of signals are present on the power line it is possible that the

Marmitek X-10 signals will not come through.

The mains do not stop at the front door of your home. Everything

that is attached to mains nearby your home can have influence on

Marmitek X-10 signals (e.g. heavy machinery). If you think that your

system is influenced by devices out of your house, it is advisable to

install FD10 Phase Coupler/Filter on each phase entering the house.

These filters will block signals coming into or going out of your

house, but will also match the impedance for the mains. Hereby

make your house Marmitek X-10 compatible for these units. To

couple the phases use a CAT 3000, see point 1 above.

INSTRUCTIONS FOR USE

APPLICATIONS/CHARACTERISTICS

• B

ecause of its extremely small proportions the module can be

built in behind built in switches and wall outlets (minimal depth

flush switch with box 40mm, preferred: 50mm). The module is

also ideal for building in light armatures and for installing in small

spaces with for instance lowered ceilings.

• Multi-purpose: fully free choice, colour and model of switch

material.

• To this module two switches can be connected. One controls

the internal appliance module, but also controls the matching

X-10 command through the power line. With the second switch

ON/OFF commands can be sent for a second X-10 address.

• The address to be set up can be programmed through the power

line with every Marmitek X-10 remote control (e.g. Marmitek

EasyControl8™ remote control withTM13 transceiver).

• The AWM2P can react to one or more group commands (ALL

LIGHTS ON, ALL UNITS OFF). These functions are disabled by

default.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Marmitek AWM2P User Manual Page 6