Marmitek SC9000 User's Guide download pdf (Page 13)

3.2

Comfort Remote Control SH624 (standard with TotalGuard, optional with SafeGuard, art. no. 09170)

1. PANIC

With this red button the panic alarm can be activated immediately.

2. CONTROL INDICATOR

Lights up when the remote control transmits radio signals when pressing the

buttons.

If the indicator light is not very bright, the batteries should be replaced.

3. CONTROL BUTTONS

For operating the security system and for the comfort functions (see 7.6).

4. DIMMER BUTTON (see 7.6)

5. MODUS SWITCH

Switch to the SEC setting to use the security functions. For settings 1 and 2, see

7.6.

SWITCH IN SEC SETTING:

ARM HOME: The security system is partly armed. All door/widow sensors

are activated, while the motion detectors are switched off.

ARM AWAY: The security system is fully armed. All sensors are activated.

DISARM: Switches off the security system.

6. HOUSECODE SWITCH

Leave the switch set to A for now (see 10.6 for more information).

3.2.1 Using the Comfort Remote Control

1. INSERTING THE BATTERIES

IMPORTANT: When inserting the batteries, the switch should not be in setting 2!

Open the battery compartment on the back of the remote control and insert the

batteries (4x AAA, alkaline). Do not forget to check the polarity (+/-). Close the compartment.

2. ACTIVATING THE SH624

Press the ‘PANIC’ button.

3.2.2 Registering the Comfort Remote Control

1. To access the menu, press the menu  or menu  button. The display will now read ‘ENTER PIN’.

2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear

on the display.

3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.

4. Press OK. The display now reads ‘INSTALL ZONE’.

5. Set the switch to SEC. Press the ARM HOME button on your Comfort Remote Control. The console will beep to confirm. The

display will read ‘RMOT 2 SET’.

a. If you have more than 2 remote controls installed, it will read e.g. RMOT 3 SET, RMOT 4 SET, … RMOT 16 SET. You can

6. Repeat step 5 for every remote control you wish to register.

7. Press CLEAR to go back to the main menu. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2

for No. If you choose Yes, you will quit the menu. If you choose No, you go back to the main menu.

☺ Read chapter 12 for information on replacing the batteries.

BASIC OPTIONS

13SAFEGUARD / TOTALGUARD

20071_20090424_UG_SC9000_EN 30-07-2009 09:10 Pagina 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Comments to this Manuals

No comments

Marmitek SC9000 User's Guide Page 13

Comments to this Manuals

Related products and manuals for Security access control systems Marmitek SC9000