Marmitek SC9000 User's Guide download pdf (Page 30)

EXTRA OPTIONS

30 MARMITEK

6. Press the zone number (27-32) followed by the ON or OFF key to set the zone. If entry correctly, the selected zone will become

flashing.

7. Repeat last step for additional zones.

8. Select the same zone again will clear it.

9. Press CLEAR to go back to the main menu. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2

for No. If you choose Yes, you will quit the menu. If you choose No, you go back to the main menu.

9.6.2 Using the Marmitek X-10 ON/OFF trigger function

ARM the system. If the zone selected by procedure above has triggered the system. The House code of the system (default A)+1,

unit code 7-12 + ON or OFF (selected by user in procedure above) will be transmitted via the mains.

Example, if user selected 32+OFF in setup, X-10 B12 OFF will be transmitted via the mains with 32 wire opened.

9.7 Deregistering a Door/Window Sensor

1. To access the menu, press the menu  or menu  button. The display will now read ‘ENTER PIN’.

2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear

on the display.

3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.

4. Press OK.

5. Enter the number of the zone you want to erase on the number pad and press CLEAR.

6. You are asked to confirm CLEAR ZONE 1. YES 2. NO.

7. Press 1 to erase the zone. The zone number is shown on the display.

8. Press CLEAR again to quit the menu.

☺ Zones 31 and 32 cannot be erased.

9.8 Deregistering a Motion Detector