Marmitek X-10 User Manual download pdf (Page 10)

ProGraMMinG

Introduction

Switch on the power supply before you start programming.

Avoid touching live parts!

The introduction to this chapter describes the basic programming actions.

Programming per function

When programming per function, one function/operation is determined for

the module and one address is determined, after which the other inputs

are automatically given the same function (or a variant of this function) and

consecutive addresses.

Basic programming actions

Module programming consists of six steps that must always be performed in

the specified order. To program the interface module proceed as follows:

1. Set the module in to Programming mode.

2. Program the address twice.

3. Program a function code twice.

4. Program any options twice.

5. Exit the Programming mode.

6. Test the operation of all the inputs.

Please note: If, immediately after putting the module in Programming

mode, an address is sent twice, the module will return to the default

value for function and options (On/Off switch commands)!

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Marmitek X-10 User Manual Page 10