Marmitek X-10 User Manual download pdf (Page 6)

on each phase entering the house. These filters will block signals coming into

or going out of your house, but will also match the impedance for the mains.

Hereby make your house Marmitek X-10 compatible for these units. To couple

the phases use a CAT 3000, see point 1 above.

inTroducTion

Congratulations on purchasing the Marmitek Micro module transmitter for

installation behind (rocker) switches or Momentary switches. Suitable for

controlling various Marmitek modules (actuators) through X-10 commands.

The TWM4 can also be used behind a (rocker) switch or Momentary switch to

start programming macros in, for example, a Marmitek CM15Pro Computer

Interface.

Note: Marmitek build-in modules should always be installed in a back

box. Due to heat generation, apply no more than one module per back

box!

Note: Inputs are only suitable for potential-free switches or contacts

<+5 volts with respect to Neutral.

FuncTions

• Can send ON, OFF, DIM, BRIGHT, All Lights On, All Units Off or All Lights

Off commands (depending on the programming).

• Adjustable for fixed mode or toggle mode sending of ON/OFF commands.

• The dimmer interface is adjustable for use with Momentary switches with

one or two, normally open contacts (optionally with zero position,

multi-switch).

• Adjustable for automatic request for status information (two-way

communication, status request).

• Adjustable for receipt of group commands for a status update in toggle

mode.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

No comments

Marmitek X-10 User Manual Page 6