Marmitek X-10 User Manual download pdf (Page 13)

TWM4™

Example

A switch actuator is controlled using a TWM4, operated with a (rocker) switch.

The switch actuator responds to the group commands All Lights On and All

Units Off. If the interface module sends an ON command, the switch actuator

will switch on. When the switch of the TWM4 is pressed afterwards, the

module would normally give an OFF command. However, if the actuator is

switched off by an All Units Off group command, the TWM4 must change its

internal status accordingly, so that an ON command is sent when the button

is next pressed.

If you wish to set one or more options, the following actions should be taken:

• Send the desired command twice from “Set-up command” using the

PRU256 programming unit or another X-10-compatible transmitter (such

as a remote control).

• The programming LED confirms the “Set-up command” with a specific

number of flashes.

• Exit Programming mode.

Option to be set Setup command No. of LED flashes

Must respond to All Units Off All Units OFF 4x

Must respond to All Lights On All Lights ON 2x

Must respond to All Lights Off All Lights OFF 3x

5. Exit the Programming mode

• Briefly press the programming button once; The red LED should now be

off, or wait 60 seconds and the Programming mode will automatically be

switched off..

Please note:

If no set-up command has been received within 60 seconds, the

module will automatically exit the Programming mode.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Marmitek X-10 User Manual Page 13