Marmitek X-10 User Manual download pdf (Page 11)

TWM4™

1. Switch the module to Programming mode

In order to program the interface module, it must be set in to the

Programming mode as follows:

• Press the programming button for at least three seconds (see Figure 5).

The red LED will light up and stay on after releasing the button.

Figure 5. Activating and deactivating the Programming mode.

2. Programming the address

Send the set-up command (letter and figure code) that belongs to the desired

address twice via the power line using a programming unit (PRU256) or

another X-10-compatible transmitter (e.g. a Marmitek remote control). The

LED will flash twice after two identical set-up commands (addresses) have

been received.

Standard Optional Setup command No. of LED flashes

Address A1 A2...P16 Address 2 x 2 x

After sending the address, the other inputs will automatically be

assigned consecutive addresses.

PROG.

TWM4

Figure 5.

PROG.

Brown

Blue

hoofdstuk 3.2

Brown

Red

Blue

hoofdstuk 3.3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Marmitek X-10 User Manual Page 11